The new WIND’S DAUGHTERS jump rope has an innovative design that takes all the torque that your arms and wrist creates just to drive double unders to another level.
Our exclusive adjusting system without surplus wire and the combination of the ring and two bearings allows you to master double and triple unders. With this adjusting system you can also change the two wires in seconds, so you don’t have to worry in which kind of pavement you have to train, just see, decide and adjust the correct wire in seconds.
Handle in aluminum with special coating for maximum resistance. // Double bearing system // Two wires included, one for indoor with rubber pavement and one for outdoor. // Ultra fast wire change. // Transport bag
ADJUSTMENT AND ASSEMBLY INSTRUCTIONS
ONE_Using the Allen tool, loose the pintle of the assembling piece.
TWO_Insert the wire inside the assembling piece
THREE_Screw the pintle to press the wire
FOUR_Engage one of the rings on the assembling piece and the engage it with the handle
FIVE_Press the wire with one foot and leave it little uptight. With one hand place the handle in vertical position. Just extending the other arm, place the ring about your armpit.
SIX_When you have this adjusted press harder with the foot, leave the handle and take the other part of the wire. Always with the wire uptight, mark or cut the wire at the armpit length.
SEVEN_Once the wire it cut, repeat 1 2 3 and 4 instructions to adjust the other handle. Your jump rope is ready for action.